Military Box Pleats: how much "excess" to cut-out of the fell?

[beerbecue]

Looks atypical due to the fact that most military box pleats are to the similar stripe in all pleats.. hence the questions...

I like the alternating stripes quite a bit

[Pleater]

It depends - like most things which are a matter of experience.

If the fabric is firmly woven then you can cut out more than if it is loose and likely to fray.

Maybe if you trim to 1 inch from the fold - as the pleats are 1 inch wide, so the number of layers are minimised but there is a smooth surface for pressing, no lumps or dips to make an uneven surface.

I have to cut out box pleats - if made in a firm fabric such as cotton, as the tapering sides of each panel are longer than the centre. It is impossible to make the fell lie flat without removing the fabric under vertical tension. Those with a need for less tapering will not have the problem.

Anne the Pleater :ootd:

[ChattanCat]

I haven't made a military box pleat but the interfacing will take the load when tightening the straps. Not sure why you would need more than 1/2".

BTW, the kilt look great!

Cheers,

[jhockin]

just to clarify - Military box-pleats look like this

It depends - like most things which are a matter of experience.

If the fabric is firmly woven then you can cut out more than if it is loose and likely to fray.

Maybe if you trim to 1 inch from the fold - as the pleats are 1 inch wide, so the number of layers are minimised but there is a smooth surface for pressing, no lumps or dips to make an uneven surface.

Anne the Pleater :ootd:

thanks Anne - I may try that; I figure always better to leave a little extra, rather than cut-out too much ; esp. since both way2fractious & JohnH both warned about leaving more seam allowance than 1/2" ( but didn't specify HOW MUCH to leave)

[jhockin]

well, without further experienced advice, I've gone ahead


I've left 2" seam allowance , along the sides, curving down to 1" above the bottom of the fell. The pleat reveal, in the fell, is about 1" wide, so, on the inside, each side of the pleat, in the fell, overlaps about 1" ( or 2 pleats).
I'll see how it works out - better too much than not enough ( i hope)

[Aspiringloser]

If the pleats are stitched to the bottom of the fell and you do proper steeking, then why do you need to leave more than 1/2 inch? I realize there is more bulk due to the extra fold but I just don't understand why you can't cut out the bulk the same as a knife pleat. Someone in the know please fill me in. What tartan are you working with by the way?

[slohairt]

I just saw this thread now. You would just leave the same amount (1/2") as if you were making a typical "tank". After all, you aren't using more fabric.

[slohairt]

If the pleats are stitched to the bottom of the fell and you do proper steeking, then why do you need to leave more than 1/2 inch? I realize there is more bulk due to the extra fold but I just don't understand why you can't cut out the bulk the same as a knife pleat. Someone in the know please fill me in. What tartan are you working with by the way?

Royal Canadian Air Force.