Pin Problems

[phil h]

I squeeze the latch a bit with a pliers. Just enough to make it snug. I've noticed that those types of latch are almost always a bit too sloppy. Another solution is a dab of rubber cement since it stays pliable and flexible when it sets.

I have tryed this too, works so far, you can imagine on the Toronto night out, one of the guys says
" anyone loose a kilt pin"? I look down and find mine has gone, it dropped off and fell in the pisser I picked it up with a paper towel and ran it under the hot water. pays to keep an eye on it evry few mins too.