X Marks the Scot - An on-line community of kilt wearers.
|
-
15th July 15, 10:17 AM
#7
If you have a little bit of your tartan on hand, a little "liner patch" for a cap badge can look surprisingly good, despite how simple it is to make. Cut a carefully chosen square of your pattern and ravel the edges out to provide about a quarter inch of fringe on all sides. Then iron a small piece of fairly sturdy interfacing on the back to give it a little stiffness. No need to sew anything, and it can be transferred with the pin or switched out as desired.
Last edited by Todd Bradshaw; 15th July 15 at 10:19 AM.
-
The Following 3 Users say 'Aye' to Todd Bradshaw For This Useful Post:
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|
|
Bookmarks