Is my kilt "off"?

[Father Bill]

I don't have a middle name, but if I did it would be Pernickety.

Anne the Pleater

I thought from your posts that your middle name was "the" as above.

[CBH]

OP - this is a lot to take in. Sorry for your plight !!

In all honesty though, I still struggled to see much wrong with it.

I'm sure it will not be easy nor cheap to get the kilt back to the maker, get them to re-work it - and hopefully fix it and not make something else worse - all in time for the wedding.

Good luck with your decision.

[Jock Scot]

Well alright, perhaps if the kilt construction is going to cause the kilt to fail in the next few years, then perhaps something needs to be done to correct that fault. Otherwise, just carry on wearing it. Also , if the “fault” niggles you that much, then the kilt needs to be returned to its maker forthwith.

[Kouzfot]

It is very possible that what has happened here is the Steeking line may have been sewn just a tad too tight.


If you can pull on the buckles and you see the pleats in the Fell Area stretch, then your kilt is not made in the Traditional manner -



and everything I have just posted is for naught.

But it is possible that what you are seeing in your kilt is due to tight Steeking Stitches and that will not be fixed by steaming. More than likely the kilt will need to be partial de-constructed to gain access to the Steeking line.

Thank you very much for a thorough reply. I will check both the standing-up technique and the pulling test tomorrow.

QUOTE=CBH;1411743]OP -
Good luck with your decision.[/QUOTE]

Thank you!

QUOTE=Jock Scot;1411745]Also , if the “fault” niggles you that much, then the kilt needs to be returned to its maker forthwith.[/QUOTE]

I'm afraid it does. I don't want it too, but I never stop seeing those things.

K

[Pleater]

I thought from your posts that your middle name was "the" as above.

Ah that is just the honorific given to survivors - you might look up Terry Pratchett's Cohen the Barbarian for comparison if you are not already familiar with him. Just don't look at him funny - Cohen that is.

Anne the Pleater

[Kouzfot]

It is very possible that what has happened here is the Steeking line may have been sewn just a tad too tight.

After all of this hidden work, the Fell Area of a Traditionally made kilt, can stand up all on its own.

Now - on your kilt, if the Fell Area cannot stand up on its own - or if you can lift the liner and there is little to nothing under it - Then your kilt is not made in the Traditional manner and everything I have just posted is for naught.

If you can pull on the buckles and you see the pleats in the Fell Area stretch, then your kilt is not made in the Traditional manner -

and everything I have just posted is for naught.

But it is possible that what you are seeing in your kilt is due to tight Steeking Stitches and that will not be fixed by steaming. More than likely the kilt will need to be partial de-constructed to gain access to the Steeking line.

Good Evening Steve!
I’ve done the test.

When I pull the buckles it stretches, but only a little bit. So little that we are talking a total of 0,5cm ish in total from one buckle to the other. So I’m pretty sure there its done proper.

Also, the kilt does stand up on its own, although not as easy as it appears on the image you attached. But I assume this has something to do with the fabric as well. If its a light, medium or a heavy kilt. I think they mentioned this being a 13 oz, but i might be wrong.

So as far as I can tell, IF there is a fault in my kilt. Then I’m leaning towards yours or Annes theory.
1. Placed on a support slightly off true before sewing together and now the inner part of the pleats are being drawn to the left

2. The Steeking line have been sewn just a tad too tight.

Perhaps it's best to send it back so they can take a look. I’ll send them a new email summarizing the thoughts from this thread and ask for their opinion.

Thank you so much for all your help so far—I’ll keep you posted!

K