I have several kilt belts. But two of the adjustable ones gave me the most problem. They both came from the same company. The large was supposed to fit a range which I was within, but near the wider end of the adjustment. When I got it. even at the widest adjustment, it was too tight. I set about figuring how I could make it work and in the mean time I ordered another belt, this time in XL size. Of course, once again, I was within the stated adjustment range, but this time near the tightest setting. The new belt arrived and lo and behold, it was too big even at the tightest setting I considered sending both of them back, but then I came up with my own solution. I purchased some black rivets and a rivet tool. Then I drilled out the rivets that hold the small "adjustment buckle on both belts and moved the buckle. The one on the large belt went closer to the belt buckle, effectively making the belt a couple of inches longer, and on the XL I moved it away from the buckle, thereby shortening the belt, After moving the buckles, I just put black rivets in the holes left where the adjustment buckles were originally located. It is difficult to tell the buckles were moved on either belt unless you look really close. My question though was how can neither belt fit when, according to the size range listed for each size, I could have worn either. Maybe I'm some weird size like 1/2 XL. Anyone know of a manufacturer that makes 1/2 XL belts?