Remember, if you're *careful*, and the Rogue isn't too stout, and you make a full-width-apron X-Kilt you can just buy 2 yards of double wide-material.

You'll have to plan carefully to figure out where the "join" will be. In fact, you could cut out the stuff, and start with the over-apron and pin the kilt up to the "join"....then trim as needed to put the join just where it will both disappear in an inside pleat fold AND won't waste material. Once that's figured out, then join the two halves and finish the kilt. I bet you can figure it out such that you won't waste more than a few inches.

$50 for a killer X Kilt?

Instead of thinking "OMG ---- TWENTY FIVE DOLLARS A YARD!!!!!"

think

"Fifty bucks for an X-Kilt?"