Its a printed image of the tartan wrapped around the liner all pens have, which allows free movement of the mechanism within. I then cast that in clear acrylic using a silicone mold and a pressure pot, then turn it down on my lathe to fit the components of the selected pen.
I tried several different ways to use actual wool tartan, silk tartan, or tartan ribbon, but they all ended up too thick or too dark/discolored, so I was reduced to using an image. But, hey, it meant any image could be used, which opened a whole world of possibilities for me! Which I've enjoyed immensely!
Piperdbh, I'm not sure I can answer your question without violating a forum rule or two. Sorry! I really like this place and I'd hate to get the boot!
Bookmarks